AuthorTopic: Smoke after Explosion looks off...  (Read 2844 times)

Offline DieMango

  • 0001
  • *
  • Posts: 67
  • Karma: +0/-0
    • View Profile

Smoke after Explosion looks off...

on: June 05, 2017, 07:30:54 pm
Can someone tell me why the smoke look just unatural?

Offline 32

  • 0011
  • **
  • Posts: 535
  • Karma: +1/-0
    • @AngusDoolan
    • http://pixeljoint.com/p/19827.htm
    • View Profile

Re: Smoke after Explosion looks off...

Reply #1 on: June 06, 2017, 02:11:15 am
You need to fade out smoke very slowly and carefully. Taking note of every particle and making sure it slowly dissolves into nothing.

Overall there's a very nice animation shaping up here ;D

Offline Schwee

  • 0001
  • *
  • Posts: 46
  • Karma: +0/-0
    • SchweeDubulus
    • View Profile
    • My Portfolio

Re: Smoke after Explosion looks off...

Reply #2 on: June 06, 2017, 06:20:09 am
Definitely not bad.  Only thing is that I can see the 'circularness' of it all throughout.  Especially for the smoke, try and spread it out more.
Looking to collaborate.  Hit me up, especially if you are a GM programmer, or if you just have some sweet ideas.

Offline DieMango

  • 0001
  • *
  • Posts: 67
  • Karma: +0/-0
    • View Profile

Re: Smoke after Explosion looks off...

Reply #3 on: June 06, 2017, 07:58:48 am
Here is the smoke a little slower...



I try to spread out everything more(had that in mind too)

Offline 32

  • 0011
  • **
  • Posts: 535
  • Karma: +1/-0
    • @AngusDoolan
    • http://pixeljoint.com/p/19827.htm
    • View Profile

Re: Smoke after Explosion looks off...

Reply #4 on: June 06, 2017, 08:56:06 am
Slower, more frames. And you're accelerating the smoke. The mass should move out quickly immediately (it's an explosion after all) and then rapidly decrease in outward speed as the smoke dissipates. The animation should start out quick and end very slow basically, in both the outward momentum and the rate at which the particles change.

Offline DieMango

  • 0001
  • *
  • Posts: 67
  • Karma: +0/-0
    • View Profile

Re: Smoke after Explosion looks off...

Reply #5 on: June 06, 2017, 09:53:50 am
Slower, more frames. And you're accelerating the smoke. The mass should move out quickly immediately (it's an explosion after all) and then rapidly decrease in outward speed as the smoke dissipates. The animation should start out quick and end very slow basically, in both the outward momentum and the rate at which the particles change.

I see...i make a new one and concentarete on those points !

Offline DieMango

  • 0001
  • *
  • Posts: 67
  • Karma: +0/-0
    • View Profile

Re: Smoke after Explosion looks off...

Reply #6 on: June 06, 2017, 09:56:04 am
Atleast its looking like some kind of Firegrenade/molotov....shoud also increase the smoke to make it look more like a frag-grenade